Dc motor

 DC MOTOR


By connecting an L298 bridge IC to an Arduino, you can control a DC motor. A direct current, or DC, motor is the most common type of motor. DC motors normally have just two leads, one positive and one negative. If you connect these two leads directly to a battery, the motor will rotate. 

         Connect 5V and the ground of the IC to 5V and the ground of Arduino, respectively. Connect the motor to pins 2 and 3 of the IC. Connect IN1 of the IC to pin 8 of Arduino. Connect IN2 of the IC to pin 9 of Arduino.    

 

Comments

Post a Comment

Popular posts from this blog

esp8266

  1. Install ESP8266 Board Support in Arduino IDE Open Arduino IDE . Go to File → Preferences . In the "Additional Board Manager URLs" field, add the following URL: bash https://arduino.esp8266.com/stable/package_esp8266com_index.json Click OK . 2. Install ESP8266 Board Package Go to Tools → Board → Boards Manager . In the search bar, type ESP8266 . Select "ESP8266 by ESP8266 Community" and click Install . Wait for the installation to complete. 3. Select the Wemos D1 Board Go to Tools → Board . Scroll down and select "LOLIN (WEMOS) D1 R2 & mini" . 4. Select the Correct Port Connect your Wemos D1 board to your PC using a Micro-USB cable . Go to Tools → Port and select the correct COM port (e.g., COM3, COM4, etc.). If no port is visible, install the CH340 USB Driver Download here . 5. Upload a Test Sketch Upload the following simple sketch to test if the board is working: cpp void setup () { Serial. begin ( 115200 ); Serial. println ( ...
Read more

1.Using an LDR (Light Dependent Resistor) with Arduino to Measure Light Intensity

Image
 Using an LDR (Light Dependent Resistor) with Arduino to Measure Light Intensity. Components Needed: Arduino board LDR (photoresistor) 10kΩ resistor Breadboard and jumper wires Circuit Connections: LDR : Connect one leg of the LDR to 5V on the Arduino, and the other leg to an analog input pin (e.g., A0). Resistor : Connect a 10kΩ resistor between the LDR leg (that goes to the analog pin) and GND. This forms a voltage divider. Explanation: When light falls on the LDR, its resistance changes, affecting the voltage at the analog pin. The analog pin reads a value between 0 and 1023 depending on the light intensity. Example Code: C++ Code int ldrPin = A0; // Analog pin to which LDR is connected int ldrValue; void setup () { Serial. begin ( 9600 ); // Start the serial communication to view the LDR value } void loop () { ldrValue = analogRead (ldrPin); // Read the LDR value Serial. println (ldrValue); // Print the value to the Serial Monitor delay ( 500 ); // Delay for...
Read more